WinBatch Tech Support Home

Database Search

If you can't find the information using the categories below, post a question over in our WinBatch Tech Support Forum.

TechHome

Installation and Licensing

Can't find the information you are looking for here? Then leave a message over on our WinBatch Tech Support Forum.

Webbatch and 500 Server Error During Configuration

Keywords:   Webbatch and 500 Server Error During Configuration

Question:

I'm trying to install WebBatch to run on Windows NT with WebSite Pro 2.2. I think that I have the CGI mappings correct, but I keep getting the following error from the server:
500 Server Error

The server encountered an error and was unable to complete your request.

Message: Couldn't find CGI output from "H:/web/esh/cgi-win/webbatch.exe"
The WebBatch error log contains the following message for the same request:
06/18/98 15:41:37 WebBatch

WebBatch Error: Not enough command-line parameters

H:\web\esh\cgi-win\y2k_indx.web
Anybody have any ideas???

Answer:

There is a section in the help file about configureing the WINCGI mappings. Either adjust them to the version in the help file, or use the preferred standard CGI stuff instead.

You need to enter "~p ~v ~i ~o ~a" in the server properties. If there is no CGI tab (or anything similar) in the Server Properties of WebSite 2.2, then use standard CGI.


Article ID:   W12482
Filename:   Webbatch and 500 Server Error.txt
File Created: 2017:07:28:12:58:12
Last Updated: 1999:04:15:15:47:32